Enhanced 2024 facelift LoopA kit with all parts included - has been discontinued - the essential kit is still available at a major discount - as long as stock lasts!

Enhanced LoopA kit with essential parts, now also including the OLED. For possible caseless use of the LoopA. Metal case can be refitted easily. Comes with new L4 keycaps. Further parts are required.

SEQ v4+ left-hand case and essential hardware (JA cable + case fastening hardware) kit.

SEQ v4+ right-hand case and essential hardware (JA cable + case fastening hardware) kit.

DIY cable tester - look mum no microprocessor! Validate IDC8/10/16 and micromatch 8/10 ribbon cables using 16x16 LED matrix graphical visualization. Full kit, including all parts and enclosure.

Ideal for mounting on Matias keyswitches. These keycaps are fully transparent and allow illuminated switches to shine through!

Superflux RGB LED with a flat top. Suitable for midiphy projects involving illuminated Matias switches.

Test your LED brightness and learn SMT soldering! This PCB gives you a simple but handy tool to identify LED pins and see how bright they will shine with specified resistor values.

Acrylic LoopA case, including necessary M2/M3 hardware. Some parts are covered in protective film/paper. Also includes rubber case feet and hex stabilization clamps.

Waveshare Core407v with bootloader. Directly upload firmware using MIOS Studio via a USB cable; no ST-Link required! 1MB flash memory.

Old version of DIY midiphy cable tester. Validate IDC and micromatch 8/10/16 pin cables - with graphical 16x16 LED Matrix connectivity visualization. New version with case: see K-UTL-02.

Shell case to hold the first-generation wirescanner PCB, including mounting hardware. Might have a few irregularities from 3D printing, but will protect your scanner PCB from scratches and short circuits on the rear.

Acrylic MULTI MIDI THRU with metal hardware and rubber case feet for stable table-top usage. This new version comes with two sidewalls for 3x or 4x TRS MIDI, supporting both new and old PCB revisions.

USB-powered quad DIN + triple 3.5mm MIDI thru board. Chainable for 8xDIN, 6x3.5mm, perfect for low-latency MIDI to multiple synthesizers and SMT soldering training.

New Version USB-powered quad DIN + quad 3.5mm MIDI thru board. Chainable for 8xDIN, 8x3.5mm, perfect for low-latency MIDI to multiple synthesizers and SMT soldering training.