product details
midiphy Wirescanner shell
Product ID: C-UTL-02
Shell case to hold the first-generation wirescanner PCB, including mounting hardware. Might have a few irregularities from 3D printing, but will protect your scanner PCB from scratches and short circuits on the rear.
Weight: 50 grams
Recommended products
These additional products may be of interest:
Note
You can put your wirescanner shell in water for 24 hours - this will dissolve the PVA stabilizing material that was used for 3D printing. Or you could just remove the outer brim with a knife and keep the inner logo made from PVA intact! :)
Introduction Video